12
Transportation and Leveling I
NSTRUCTIONS
”
H
OW TO ADJUST THE LLEVELING ENDCAPS ON THE REAR STABILIZER
a. After placing the equipment in its intended location of use, check the stability
of the equipment
b. If the equipment has a rocking motion due to an unleveled floor. You must
level the equipment by turning one or both of the
Leveling End Caps (27)
in
the clockwise or counter-clockwise direction until the equipment sits on the
floor without rocking
H
OW TO ADJUST CONSOLE ANGLE
To get the best console angle, it
’s suggested to use both hands to hold the upper and lower end of
the console and gently tilt the console to the best viewable angle.
H
OW TO MOVETHE ITEM SAFELY
Carefully pick the
Rear Stabilizer (3)
up with two hands and pull the
item to the new location
Make sure the floor is level where you are moving the item
H
OW TO ADJUST THE STAND ON THE MIDDLE OF MAIN FRAME’S
BASE
NOTE:
The purpose of adjust the
Leveler (23)
is to level the item and get more support to the
base of the Main Frame. After finishing the assembly process, you may need to adjust this
leveler again. Place the item on a flat surface and adjust the
Leveler (23)
until the item sits on
the floor without rocking, then tighten the
Nut (114)
securely against the
Main Frame (1)
.
Summary of Contents for VT-3.4
Page 40: ...40 PRODUCT PARTS DRAWING A...
Page 41: ...41 PRODUCT PARTS DRAWING B...
Page 45: ...45...
