7
Taifun
GT one
®
8. CLEANING
Do not use cleaning agents as they could harm the O-Rings.
Before assembling, check the completeness and positioning of the O-Rings to prevent leakage of liquid.
•
Disassemble the device into its components.
•
Clean the components (not the cotton) with warm water or in an ultrasonic bath.
•
Completely dry the components before reassembling the device.
9. MAINTANANCE
•
Wait until the device has completely cooled down before disassembling, to prevent burns.
•
Make sure that there is no power supply by unscrewing the device from the mod or by switching off the mod.
ASSEMBLING DEVICE
•
The device is usually delivered fully assembled, the following instructions are for the assembly after cleaning.
•
Moistening the sealing rings with liquid makes the assembly easier.
•
Please use only suitable tools for assembly.
The positive pole [N] is plugged into the positive pole isolator [B]
The isolator [E] is inserted into the base [A] from below.
Now the positive pole [N] with the isolator [B]
is pushed into the base [A].
Then push the positive pole screw [C] from below through
the base [A] and fix the positive pole [N].
The grub screw [F] is screwed into the base [A] from the side.
(optional)
A suitable air pin [Q] is inserted into the positive pole [N].
(optional)
P
G
R
H
