Before Using Your Propane Grill
Before Using Your Propane Grill
Connecting LP Gas Cylinder
Disconnecting LP Gas Cylinder
How to Perform a Leak Test - “FIRST TIME USE”
1. Purchase 1lb. LP gas cylinder at your local retailer.
2.
Turn the regulator knob to the “Off” position.
3. Remove protective cap from regulator opening. Remove plastic cap
from top of propane cylinder. Save cylinder cap for replacement on
cylinder if gas remains in cylinder after use.
4. Insert the 1lb. LP gas cylinder into the threaded hole in the underside
of the regulator. Turn the cylinder clockwise until firmly seated. Hand
tighten only.
5.
For optimum performance, allow clinder to hang vertically off the
edge of the table when there is no danger of being bumped or
disturbed.
NOTE: NEVER FOLD UP OR TRANSPORT GRILL WITH CYLINDER ATTACHED.
Installation Safety Precautions
• Use only 1 lb. (16.4 oz) disposable cylinder (DOT39 Cylinder) that is 7-3/8 in. high (not included).
• Only cylinders marked “propane” must be used. The cylinder must be disconnected when the appliance is not in use.
• The pressure regulator supplied with the appliance must be used.
•
Replacement pressure regulators must be those specified by the manufacturer.
• Cylinder supply system must be arranged for vapor withdrawal.
• Do not store a spare LP-gas cylinder under or near this appliance.
•
If the instructions are not followed exactly, a fire causing death or serious injury may occur.
1.
Turn regulator knob to the “Off” position.
2. Remove the cylinder by turning counterclockwise.
3. Replace the protective cap over the regulator opening. Replace the
plastic cap on the top of propane cylinder for storage if not empty.
4. Store cylinder outdoors and away from grill.
SUPPLIES NEEDED:
• Clean paint brush, water, dish washing liquid and an empty bowl or can
1.
Make sure the regulator knob is turned to the “Off” position and verify
that the LP gas cylinder is tightened securely to the regulator.
2. Mix one part of water with one part of dish washing liquid.
3. Brush mix on regulator, propane cylinder and connection as indicated
by the heavy arrows in the figure below. If bubbling occurs, there is a
gas leak.
4. If leak appears at the regulator/cylinder connection, repeat cylinder
installation procedure, but do not overtighten. (NOTE: Only hand
tighten) Repeat leak test.
A. If the leak is coming from the gas cylinder or if the leak cannot be
stopped, remove the cylinder and DO NOT USE THE GRILL. Call
Customer Service at 1-866-475-5180. Be sure to have the grill model
number and serial number printed on the label, located on the inside
of the rear leg. If you need a replacement part that is under warranty,
a proof of purchase will be necessary.
Hand-tighten
cylinder in
clockwise
direction
9
