1. Unlatch the Sprayer from the Bucket by rotating
Locking Handle towards the outside of the Bucket.
2. Remove the Sprayer. Fill the Bucket with material to be
Sprayed then reinstall & latch the Sprayer.
3. Make sure the power switch is in the off
(counterclockwise) position.
4. Insert the battery into the receptacle.
5. Check the sprayer trigger handle to make sure the lever
is not locked in the open/on position.
6. Turn the power switch to the On position (Clockwise)
and squeeze the trigger handle to begin “priming” the
pump. The Pump is self priming and should begin
spraying in a few seconds. Priming time will vary
depending on the fluid viscosity and temperature. If the
pump does not prime within 20 seconds, turn off the
power and check to see that all fittings are tight and the
Intake Filter is not clogged.
7. After liquid is flowing and all air is purged from the lines,
release the Handle and the Sprayer will turn off.
8. You are now ready to begin spraying your material.
9. If the Pump sounds or runs erratic, reduce pump speed
until it runs smooth or lower to achieve desired spray
pattern.
Be certain the fluid being pumped is compatible with the
pump and Sprayer materials EVA, POM, Santoprene and
Polypropylene. For a partial list of compatible fluids see
appendix A. If it is not listed or you are unsure, contact your
chemical supplier.
The pump is intended for continuous or intermittent duty
when the proper operating criteria are met.
Page 9
SMK shall in no event be liable for death, injuries to
persons or property or for incidental, contingent, special or
consequential damages of any kind by the reason of use or
sale of any defective product or part. This limited warranty
covers units distributed in the United States of America
only.
This limited warranty is in lieu of all other warranties,
expressed or implied, and no other person is authorized to
give any other warranty or assume obligation or liability on
behalf of SMK Industries, Inc.
Products and parts must be flushed free of all fluids prior to
returning to SMK for warranty inspection.
PROOF OF PURCHASE
Please retain your dated sales receipt as proof of purchase
to validate the warranty period.
SPECIFICATIONS
Integral pump
LEITE Model: GB-2438ZY
Pump motor voltage
12 Volt
Chassis
Powder coated steel
Trigger
Chapin
Wand
Chapin
Wand tips
Chapin
Batteries to use
Lithium Ion 18V or 20V
Page 6
Operation
ratio
