J
2009-07
WW1924-ADD7 REV 0
b
s
TM
Page 1 of 4
6
For use by or on the order of a licensed physician.
f
Attention, see operation manual for additional instructions for use.
Quick Reference Guide
WW1030
BCI® Simplified Operation Guide
Pulse Oximetry Monitoring
Insert the sensor cable connector into the port located on top of the device.
1.
Press the
2.
On/Off
key (
x
) to turn the oximeter on.
Place the sensor on the monitoring site.
3.
SpO
4.
2
,
pulse rate, pulse strength and Pulse amplitude Index (PI) bar will be displayed.
Pulse Volume
From monitoring mode, use Up/Down arrow keys (
1.
n
o
) to raise or lower pulse beep volume.
Continue to press the Down key to silence the pulse tone completely.
2.
Silencing Alarms
Audible alarms can be silenced for two (2) minutes.
1.
To silence the alarm tone, briefly press the Alarm Silence key (
2.
B
).
The Alarm Silence indicator will light solid for the first minute and 45 seconds, then flash the last 15 seconds.
3.
To cancel the 2-minute silence, briefly press the Alarm Silence key (
4.
B
).
NOte: the Alarm Silence key will not affect visual alarm indicators or pulse tone.
Changing the Alarm Limits
To change the alarm limits, press the
1.
Menu
key (
) until the desired parameter’s alarm limit is displayed.
Press the up or down key (
2.
n
o
) to increase or decrease the setting.
Press the
3.
Menu
key (
) to advance to the next alarm limit.
To exit, press the
4.
Exit
key (
) or wait 20 seconds until the patient reading is displayed.
entering Setup Menu
Power oximeter on by pressing the
1.
On/Off
key (
x
) located on the device’s upper right side.
When the patient number (Example:
2.
P1) is displayed, press and hold the
Exit
key (
) and then
press the
Menu
key (
).
The Averaging Menu will be the first option.
3.
AVG will be displayed. Release the
Exit
key (
).
