Smithco Fairway Ultra 10 12-500-B, Parts & Service Operators

Page: 9 / 46

7
Maintenance
MAINTENANCE
Before servicing or making adjustments to machine, stop engine on tow vehicle and
remove key from ignition. Securely prop FairWay Roller on jack stands.
Use all procedures and parts prescribed by the manufacturer.
Before operating this machine, become familiar with all controls and functions of this unit and the tow vehicle.
Also complete all maintenance requirements and read all safety warnings. By knowing both machines thor-
oughly, how it operates and by doing the prescribed maintenance steps, you can expect relatively trouble-free
operation for years to come.
TOW VEHICLE
You will need a heavy duty vehicle with 4 wheel brakes.
Transport Frame Assembly requires a clevis hitch and a
3
/
4
diameter by 4" pin with some type of lock. Tow
vehicle must be capable of 550 lb tongue weight.
Always drive at a safe towing speed relative to conditions and ensure that your speed is low enough for an
emergency stop to be safe and secure. Smithco recommends a maximum speed of 8mph (12 kph).
DAILY CHECKLIST
1. Check engine oil level in tow vehicle. Add as needed. DO NOT OVERFILL.
2. Check Fairway Roller for loose or missing nuts, bolts, screws, etc., and tighten or replace as needed..
3. Check that all rollers are in good condition.
4. Grease bearings daily after each use.
5. Check hydraulic hoses for any leaks or loose connections.
6. Check tire pressure. 18 psi (1.3 bar)
7. Check electrical system for loose connections or frayed wiring, including battery cables. Replace any
faulty equipment or tighten if loose.
OPERATION SAFETY
1. Before operation check to see that rollers are rotating properly.
2. When not in use, remove the jack pin and extend the legs to maximum extension, reinsert the jack pin
and secure with a clip. Always use jack stands for safe storage.
LUBRICATION
Use No. 2 General Purpose Lith-
ium Base Grease and lubricate
DAILY. The Fairway Ultra 10 has
13 grease fittings, one on each pil -
low block (A). One on each Roller
Shaft Housing (B). One on Right
and Left Wing (C). Two on Rear
axle (D). When inserting grease,
be careful not to ruin the seal, if
this happens, replace the seal at
once. Be sure to wipe grease fit -
ting clean before injecting grease.
Give only one or two pumps of
grease at each lubrication.