01/2018
Form# 179773
www.smithsystem.com
3
Step 1: NOTE: You will assemble the legs while the contents (Top Sub Assembly) are
still in the shipping box.
Remove the filler pieces on each end. This should allow some working room to
attach the legs.
You may break down the short ends of the box to gain more access to the ends.
Attach the legs to the front brace and rear brace. Make sure the pinholes on the
legs are facing the desk.
(4) Connector Bolts, (2) per leg. (See drawing 1A).
Step 2: There are (8) connector bolts enclosed in the box with the legs. Using these
connector bolts, attach the legs as shown below. Use the two enclosed allen
wrenches to tighten the bolts from both sides
Pilot Hole
Facing Inward
