3
What’s in the box?
•
Instruction manual
•
Handle
•
Spare parts (hopefully you won’t need these)
I received my wine or beverage cooler, now what?
Your wine or beverage cooler was designed to be built into kitchen or bar
cabinets or it will work just fine as a stand alone appliance. Your choice.
You should place your wine or beverage cooler on a flat, solid floor that is
strong enough to support it when it is fully loaded (300-700 lbs). To level
your appliance, adjust the front leveling leg at the bottom of the cabinet.
Locate the appliance away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the UV coating on your
glass door, extreme heat or cold will also cause the unit to perform improperly.
Avoid locating the appliance in damp areas.
Plug the appliance into a dedicated (for this appliance only), properly
installed and grounded wall outlet. Do not under any circumstances cut or remove
the third (grounding) prong from the power cord. Any questions concerning power
and/or electrical grounding should be directed to a certified electrician or
authorized product service center.
Handle Installation
Step 1. Line up the screw holes on
the handle with the screws on the
front of the door. The screws will
line up perfectly with the screw holes
on the handle, depending on your door
style. It could be either the upper
or lower portion of the handle.
Step 2. Push the black rubber door
gasket to the side to reveal the
screw on the inside of the door.