Smeg TLS10, Instructions For Use Manual

Page: 9 / 17

Loading the laundry
1. Open the machine lid by pulling it upwards.
2.
Open the drum
- by pushing the drum flap release (for “ 1a ”
and “ 1b ”; models as shown on “ 1a ” have
a fixed drum flap release which will not
compress when pushed).
- by holding the rear drum flap, sliding back
the slider into arrow direction and pushing
the front flap towards the inside of the drum
until the closing mechanism releases (for “ 1c ”).
3. Place the items of laundry into the drum one
by one. Do not exceed the maximum load
of the programmes indicated in the separate
programme chart.
- Overloading the machine will result in
unsatisfactory washing results and creased
laundry.
- Take care that the laundry does not
overhang the drum; if this is the case, push
the laundry down into the drum so that
there is enough free space to close the
drum flaps properly.
- Do not use the flaps to push the laundry
into the drum.
4. To close the drum, hold both flaps in the
middle again (picture “ 2 ”), the rear flap over
the front flap.
ATTENTION : make sure that the drum
flaps are properly locked - depending on the
model:
- the metal hook must be completely
hooked into the rear door flap - see picture
“ 2a ”, or
- all metal hooks must be properly hooked
inside the rear door flap, and the button
must overlap the edge of the rear door flap
- see picture “ 2b ”.
- the slider of the front flap must slightly
overlap the rear flap - see picture “ 2c ”.
Check that no laundry gets stuck between the flaps,
or between flaps and drum.
GB 7
2
2b 2a
2c
1c
1a
1b