Smeg SI2M7643DW, User Manual

Page: 7 / 21

One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N
N Blue and blue Blue and blue N
L Black and brown Black L1
Brown L2
Attaching the seal - On-top
installation
1. Clean the worktop around the cut out
area.
2. Attach the supplied 2x6mm seal stripe
to the lower edge of the hob, along the
outer edge of the glass ceramic. Do
not stretch it. Make sure that the ends
of the seal stripe are located in the
middle of one side of the hob.
3. Add some millimetres to the length
when you cut the seal stripe.
4. Join the two ends of the seal stripe
together.
Attaching the seal - Integrated
installation
1. Clean the rabbets in the worktop.
2. Cut the supplied 3x10mm seal stripe
into 4 stripes. The stripes must have
the same length as the rabbets.
3. Cut the ends of the stripes at an angle
of 45°. They should fit in the corners of
the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not stretch the stripes. Do not bond the
ends of the stripes one over the other.
After you assemble the hob, seal the
remaining gap between the glass ceramic
and the worktop with silicone. Make sure
the silicone does not get under the glass
ceramic.
Assembly
min.
50mm
min.
500mm
min. 60mm
If the appliance is installed
above a drawer, the hob
ventilation can warm up the
items stored in the drawer
during the cooking process.
You can instal a separation
panel but it is not mandatory.
7