Smeg SBQ36X, Instruction Manual, Page: 7 / 12

EN
7
7
Mounting the hood body
• Adjust the two screws Vr of brackets 11a, by just placing them
in position.
• Hook the hood body to the two brackets 11a.
• Remove the filters one at a time, supporting them with one
hand and turning the safety knobs (pull and turn).
• From inside the hood body, tighten the screws Vr to level the
body.
Vr
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the
chimney using a rigid 150 mm duct.
• Install the damper
10 ø 150 mm.
• Fix the duct in position using sufficient pipe clamps (not sup-
plied).
• For rear install ducted version air :
a) From inside the hood, unplug wire attached to blower motor.
b) Turn the hood over and remove the screws holding the ex-
haust blower assembly to the hood.
c) Rotate the blower assembly so that the exhaust collar is fac-
ing out the back of the hood.
d) Replace the screws holding the blower assembly to the hood.
e) Plug the blower motor wire back into the blower motor.
10