Installation
21
EN
Dual Flame burner
1. Remove the tightening screws (
5
), the
cover plate (
6
) and the gasket (
7
).
2. Remove the internal (
8
) and external (
9
)
nozzles and replace them according to
the type of gas to be used and the
description in section “Burner and nozzle
characteristics table”.
3. Refit the burner components correctly.
Test for gas leaks
After the conversion it is important to verify
the leakages and correct appearance of
the flames. (see page 16).
Conversion kit list of components
The conversion kit consists of the following
components, based on the model:
Both 30” and 36” models:
• One Gas Conversion label:
• One seal gasket 12.5x18.5x2 (mm) -
0.5x0.73x0.08 (in).
For 30” models only:
• One label for LPG injectors
.
• One injector
Ø 1.17
mm for the
Dual
Flame
burner (outer ring).
• One injectors
Ø 0.48
mm for the
Dual
Flame
burner (inner ring).
• Three injectors
Ø 1.02
mm for the
Rapid
burners.
NOTE
: There are no burner parts
under the cooktop to clean,
disassemble or adjust.
Summary of Contents for RTU304GX
Page 22: ...PAGE INTENTIONALLY LEFT BLANK...
