User instructions
13
DELAY PROGRAM
(on some models only)
Pressing button
DELAY PROGRAM
(3)
in sequence delays the start of the program by
3
,
6
or
9
hours
. This allows you to set the dishwasher to work at specific times of day.
After selecting the delay, start the program in the normal way (see relative section).
The appliance will prewash the dishes, after which the “delay program” set previously will come into
effect (the phase lights switch off and the light relating to the delay set flashes).
To
reset or change the delay
once the program has started:
•
press
the
START/PAUSE
button
(5)
for a few seconds, until the
PROGRAM PHASES
lights
(10)
come on;
•
press
the
DELAY PROGRAM
button
(3)
several times
“until the program delay” returns to zero
(all the lights indicating the delay go out);
•
press the
START/PAUSE
button
(5)
to start the new program.
To set the delay
once the program has started
, proceed as follows.
If the program you wish to carry out is the same as the one already in progress:
•
press
the
START/PAUSE
button
(5)
for a few seconds, until the
PROGRAM PHASES
lights
(10)
come on;
•
annul the program in progress (see relative section) and wait for the cycle to come to an end;
•
select the program again;
•
select the delay required;
•
press the
START/PAUSE
button
(5)
to start the new program.
If the program you wish to carry out is different from the one already in progress:
•
press
the
START/PAUSE
button
(5)
for a few seconds, until the
PROGRAM PHASES
lights
(10)
come on;
•
change the program;
•
select the delay required;
•
press the
START/PAUSE
button
(5)
to start the new program.
The dishwahser will pump out
the water and restart with the delay set and the new program.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
•
Always try to run the dishwasher
fully loaded
.
•
Do not wash the dishes in running water.
•
Use the washing program that is
most appropriate
for each type of load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
•
When possible,
skip the drying cycle
by leaving the door open when the washing cycle is
complete; the air and the residual heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
•
separate
the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
•
do not pour
the detergent directly on the dishes.
REMOVING THE DISHES
The door can be opened at the end of cycle approximately
50mm
for improved drying
performance.
At the end of the washing program, wait at least
20 minutes
before removing the
dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling
on the dishes in the lower basket, it is
advisable
to unload the lower basket first, and then the
upper basket.
