Instructions for the installer
6
2. INSTALLING THE APPLIANCE
IIt is the law that all gas appliances are installed by
authorised persons
. Clearance around the cooker
must comply with the requirements of AS5601.
2.1 Electrical connection
After making the electrical and gas connections, level the the appliance on the ground by means of its
four adjustable feet. For good cooking results, the appliance must be properly levelled. Depending on the
model you have purchased, the foot height adjustment range may vary from 70 to 95 mm and from 110
to 160 mm. These heights refer to the distance between the highest point of the foot (fixed part) and the
lowest point (movable part which rests on the floor).
2.2 Electrical connection
Make sure that the power line voltage matches the specifications indicated on the rating plate located
inside the storage compartment.
This rating plate must never be removed.
The plug on the end of the power supply cable and the wall socket must be of the same type (in
compliance with the relevant national standards). Check that the power supply line is properly earthed.
The use of reductions, adapters or junctions is not recommended.
The appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at
least
3 mm
, located in an easily accessible position close to the appliance itself.
The wire section on the cable must not be less than 1.5 mm
2
(3 x 1.5
cable), keeping in mind that the end to be connected to the cooker
must have the ground wire (yellow-green) longer by at least 20 mm.
Use only the special cables available at our Service Centres.
For operation on
220-240V~
: use an H05V2V2-F type three-core
cable (3 x 1.5 mm
2
).
The manufacturer declines all responsibility
for damage to persons or things caused by non-
observance of the above prescriptions.
Overall dimensions: location of gas and electrical connection points (all measures in mm).
90 cm
A
60
B
600
C
110
D
145
