EN
1
17
INSTALLATION
Drilling the Support surface and Fitting the Hood
• The Hood can be installed directly on the
underside of wall-mounted units (650 mm
min. from the Cooker Top) using the snap-
on side supports and screws provided.
• Create an opening in the bottom of the wall
mounted unit, as shown (fig.1), leaving a
distance of at least 20mm from the front.
• Fit the two hood support brackets (fig.2)
using the screws
12a
(3.5 x 16) at a distance
B
of min. 85mm - max. 165mm. The
brackets must be fitted differently according
to the size of the hood to be mounted.
• Remove the Comfort Panel (see the
paragraph on Maintenance).
• Remove the metal grease filters one at a
time, releasing the fasteners provided (see
the paragraph on Maintenance).
• Remove the profile after unfastening the 4
screws that fix it to the Hood (fig.4).
• Remove any Activated Charcoal Filters (see
the paragraph on Maintenance).
• Insert the Hood until it connects with the
snap-on side Supports. (fig.3)
• Lock it in position by tightening screws
Vf
from underneath the Hood. (fig.3)
• It is now possible to fasten the hood to the
wall-mounted unit using the screws
12a
(3.5 x 16) provided. (fig.4).
• Replace the profile, using the 4 screws
removed as above.
• Replace the filters.
• Replace the Comfort Panel.
B
1
2
12a
4
Vf
3
493 - 723
273
