EN
2
27
Activated Charcoal Filter (Recirculation Version)
This cannot be washed or regenerated, and must be changed when
G
starts to flash, or at least
once every 4 months. The Alarm signal, if it has been activated, only appears when the Suction
motor is turned on.
Activating the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on
installation or at a later date.
• Turn the Lights and the Suction Motor off.
• Press
F
and hold for approximately 5 seconds:
•
Button B
flashes twice -- A.C. Filter saturation alarm
ACTIVATED
•
Button B
flashes once -- A.C. Filter saturation alarm
DEACTIVATED
CHANGING THE ACTIVATED CHARCOAL FILTER
Resetting the alarm signal
• Turn the Lights and the Suction Motor off.
• Press button
G
and hold for approximately 5 seconds (See
paragraph on Use).
Changing the Filter
• Remove the metal grease filters.
• Remove the saturated charcoal filter by releasing the fixing
hooks
• Fit the new filter and fasten it in its correct position.
• Put the metal grease filters in their seats.
Lighting
LIGHT REPLACEMENT
20 W halogen light.
• Remove the snap-on lamp cover by levering it from under the
metal ring, supporting it with one hand.
• Remove the halogen lamp from the lamp holder by pulling
gently.
• Replace the lamp with a new one of the same type, making
sure that you insert the two pins properly into the housings on
the lamp holder.
• Replace the snap-on lamp cover.