5
Controls
Button Function
Led
A
Turns the Motor off.
The Leds indicating the Speed of the motor turn off.
B
Activates speed one.
The Leds indicating Speed one and Motor Off turn on.
C
Activates speed two.
The Leds indicating Speed two and Motor Off turn on.
D
Activates speed three.
The Leds indicating Speed three and Motor Off turn on.
E
Activates Intensive speed. This speed is timed to run for 6
minutes. At the end of this time the system will automatically
return to the speed set before.
It is disabled by pressing the Button or turning the Motor off.
Flashes once a second.
F
Starts the 24H function, in which the motor starts at a speed
that allows suction of 100 m3/h for 10 minutes per hour. This
mode cannot be activated if Intensive or Delay modes are
active.
To turn it off press the button again.
The Leds indicating F speed and Motor Off turn on.
When the filters alarm is triggered, the alarm can be reset by
pressing and holding this button for approximately 5 seconds.
Led A flashes three times.
These indications are only visible when the motor is turned
off.
When the procedure terminates, the indication shown previously
turns off:
F Flashing
Indicates the need to change the activated charcoal filters, and also
to wash the metal grease filters. The alarm is triggered after the
Hood has been in operation for 100 working hours.
G
Activates Delay mode, causing automatic shutdown of the
Motor and the Lighting system with a 30’ delay.
It is disabled by pressing the button or turning the motor off.
This mode does not function if Intensive or 24h is active.
Led G turns on, and the button for the selected speed flashes every
0.5”
H
Turns the lighting system on and off at maximum intensity.
The Lighting Led lights up.
On start-up the board recognises the mains frequency.
Recognition is indicated on the display:
- 50Hz: LED A flashes once
- 60Hz : LED A flashes twice
Lighting
• For replacement contact technical
support (“To purchase contact
technical support”).