2-3. Connection of Water Filter (In case of External Filter Models).
2-4. Connection to the Water Tap (In case of External and Internal Filter Models).
2-5. Water Supply
1) After the installation of feed water, plug the refrigerator
Now you have cut the pipe from the back of the appliance to lenght. It needs to be attached to the water filter. The filter
is marked with with the direction of the water flow (i.e. from tap to fridge).
Just insert tube into the end of the filter that the flow arrow points
until the tube stop. (See Fig. E)
After inserting tube, put together the clip strongly. The clip fix
the tube. (See Fig. F)
Remember however that the connection is being done from the refrigerator to the tap (i.e. the reverse of the water flow when in use).
to the earthered wall outlet, press the water dispenser
button for 2 - 3 minutes, and confirm that the water
comes out.
2) Check leakage at connecting part, then arrange water
tube and locate the refrigerator at its regular place if
there is no leaking.
HOW TO INSTALL REFRIGERATOR
- 10 -
Note the direction markings on the filter!
Repeat on the other end of the filter using the remainder of
the water pipe. (See Fig. H)
Cut the pipe that is connected to the water filter to the correct lenght. Again, make
sure that the cut is nice and square to avoid leaks.
Push the pipe into the smaller hole of the connector supplied in the plumbing
adapter kit. The pipe should be held firm. (See Fig. J)
Place the rubber washer inside the threaded tap connector and screw onto water tap.
CAUTION:
feed pipe should be connected to cold water line. If it’s
connected to hot water line, trouble may occur.
If you have connector type filter, put together the clip strongly.
The clip fix the tube. (See Fig. I)
Water Tube
Water Tube
Nut
Summary of Contents for GW-L227
Page 104: ...MAY 2009 Printed in EU ...
