Smeg FR235A, Instructions For Use Manual

Page: 7 / 27

18
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
1. The appliance is not working.
•
Is there a power failure?
• Is the plug properly inserted in the socket?
• Is the double-pole switch on?
• Has the fuse blown?
• Is the power cord in perfect condition?
• Is the thermostat set to
●
(Stop)?
2. Temperature inside the compartments is
not low enough.
• Is the door shut properly?
• Is the appliance installed near a heat source?
• Is the thermostat setting correct?
• Are the air circulation grilles blocked?
3. Temperature inside the refrigerator
compartment is too low.
• Is the thermostat setting correct?
4. Water collects at the bottom of the
refrigerator compartment.
• Is the defrost water drain blocked?
5. The inside light is not working.
Perform the checks for problem 1, then:
• Disconnect the appliance from the mains power
supply.
To inspect the bulb, refer to the instructions and
illustration on the attached table.
• Check the bulb and if necessary replace it.
Replace using maximum 15W bulb.
6. Excessive frost build-up in the freezer
compartment
• Is the door shut properly?
• Is food obstructing proper door closure?
Notes:
•
The front edge of the appliance may be hot.
This prevents the formation of condensation
and is not a defect.
• Gurgling and hissing noises due to expansion
in the refrigerant circuit are normal.
For built-in appliances
• Periodically clean air vents with a vacuum cleaner or a
brush (see figure A).
• Clean the outside using a soft cloth.
Freestanding appliances
• Periodically clean the condenser at the rear of the
appliance with a vacuum cleaner or a brush (see figure B).
Long vacation
1. Empty the refrigerator and freezer compartments.
2. Disconnect the appliance from the mains power supply.
3. Defrost the freezer compartment, and clean and dry both
compartments.
4. Leave the doors open to prevent formation of unpleasant
odours.
Fig. A
Fig. B
63633043GB.fm Page 18 Saturday, March 5, 2005 3:25 PM