Instructions for Use
20
Channelling the condenser tube to the drain
outlet
Take off the condensed water drawer tube from
the rear side of the dryer and by fitting an elbow
on it channel the tube into the drain outlet. Height
of the drain must not exceed 800 mm.
Connecting to Power Supply
The appliance is connected to the power supply
by means of a cable cord plug. The wall socket
should be earthed (safety socket). Required
nominal current and frequency are stated on the
rating plate. The wiring should withstand
maximum load. Electric connection and earthing
should be carried out in accordance with current
standards and regulations.
IMPORTANT
In the supply cord is damaged, it must be
replaced by the manufacturer or his service agent
or a qualified person in order to avoid hazard.
•
The appliance should be placed in the position,
where the plug is within reach.
Door
Door of the dryer can be opened by pressing the
door frame against the machine, as shown in the
figure.
The door is closed in the same way, If the door is
not closed properly the machine will not operate.
Be careful not to pinch the laundry with the door
as it might get damaged.
IMPORTANT
You may open the door during drying. The
operation of the machine is interrupted, but it
goes on as soon as you close the door.
