Instructions for Use
19
Positioning and Installation
Your drying machine can be placed in any room
with adequate ventilation.
Choosing the Right Place
A - Venting - type Dryer
The most suitable place is a room with a window
or with an air-conditioning fan, which is mounted
into air-duct or guided out in the open (Figure 1).
In closed, smaller rooms without adequate
ventilation there is too much moisture in the air,
drying time is increased and so is energy
consumption.
If during the drying procedure there isn't adequate
ventilation in the room, we recommend you direct
moist air out in the open by means of vent pipe
(Fig. 2).
2
1
Vent pipe can be bought in any technical store
(identification code PIPE SP-377628).
B - Condenser - type Dryer
Do not install the condenser dryer into the room
where a danger of freezing can occur. Freezing
of water in the condensed water drawer and the
pump can damage the appliance.
Positioning
This dryer is a self standing appliance and can
stand alone, or it can be placed either together
with a washing machine or in the kitchen as a
kitchen unit.
If the floor is uneven, use the adjustable feet to
level the machine.
3
3a
Undo the nuts. Rotate the feet to level the
machine (fig. 3).
Lock the nuts (fig. 3a).
•
Do not remove the adjustable feet. The
machine must be placed horizontally.
•
Some models of tumble dryers are supplied with
vacuum leg braces, enabling the appliance to
be placed on top of a washing machine, without
hazard of falling or tripping during the operation
of either appliance.
•
Do not put the dryer on the thicker rug thus
preventing the possibility of air circulation.
Moist Air Outlet
A – Vent dryer
There are two openings for venting out humid air,
which are situated at the bottom left-hand rear
side part of the dryer. Depending on the position
of the machine, please, close down one of the
openings with the front cover, which has already
been fastened on it, or attached to the drum
(Fig 4).
Fix the cover by inserting a coin into the slash
turning it clockwise. It can be removed by turning
in the opposite direction.
If during the drying cycle the airing is not good
enough, the air-vent tube can be inserted
(screwed) into the hole. The distance between
the dryer and venting opening (airduct or window)
must not exceed two meters, otherwise
condense can accumulate in the tube, (Fig 5).
1 Decorative cap
2 Vent pipe
B –
Condenser - type Dryer
Humidity from the laundry in the condenser dryer
is extracted into the air cooler and accumulated in
the drainage container or conducted directly into
the moist air outlet. After every drying the
condensed water drawer should be emptied, of
which you are reminded by the control lamp
which is on when the container is full. The air
cooler should be cleaned in time (see the chapter
Maintenance and Cleaning)
4
5
