Smeg DR72IN, Manual

Page: 5 / 20

5 EN
2
Installation
Refer to the nearest Authorised Service Agent for
installation of your product.
C
Preparation of location and electrical installation for
the product is under customer’s responsibility.
B Installation and electrical connections must be carried
out by a qualified personnel.
A
Prior to installation, visually check if the product
has any defects on it. If so, do not have it installed.
Damaged products will cause risks for your safety.
Appropriate installation location
• Install the product in an environment which has no risk
of freezing and is in a stable and level position.
• Operate your product in a well ventilated, dust-free
environment.
• Do not block the air ducts in front of and under the
product with materials such as long pile rugs and
wooden bands.
• Do not place your product on a long pile rug or on
similar surfaces.
• Do not install the product behind a door with a lock,
sliding door or a hinged door which can strike the
product.
• Once the product is installed, it should stay at the
same place where its connections have been made.
When installing the product, make sure that the rear
wall of it does not touch anywhere (tap, socket, etc.)
and also pay attention to install the product at a place
where it will stay permanently.
B
Do not place the product on top of the power cable.
• Keep at least 1.5 cm distance to walls of other
furniture.
Removing the transportation safety
assembly
A Remove the transportation safety assembly before
using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that contains a
piece of styrofoam. Hold it from its section marked
with XX.
3. Pull the nylon towards yourself and remove the
transportation safety assembly.
A
Make sure that you have removed the transportation
safety assembly (nylon+styrofoam pieces) before using
the product for the first time. Do not leave any items
inside the drum.
Under counter installation
• Leave at least 3 cm of space between the side and
rear walls of the product and the walls of the counter/
cupboard when installing your product under a counter
or in a cupboard.
Mounting over a washing machine
• A fixing device should be used between the two
machines when installing the dryer above a washing
machine. The fixing device (KITSPF-1) must be installed
by the Authorized Service Agent.
• Place the product on a firm floor. If it will be placed on
top of a washing machine, the approximate weight of
both machines may reach 180 kg when they are full.
Therefore, the floor must be capable of carrying the
load on it!
Connection to water drain;
In products equipped with a condenser unit the water
accumulated during the drying cycle is collected in the
water tank. You should drain the accumulated water after
each drying cycle.
You can directly send the accumulated water out through
the water drain hose supplied with the machine instead of
periodically draining the water collected in the water tank.
Connecting the water drain hose;