Smeg CWG410M, Manual

Page: 28 / 30

‐ CWG410 ‐
28
PROBLEM
POSSIBLE CAUSE POSSIBLE REMEDY
connection diagram.
DISHES NOT PROPERLY
DRIED
Low rinsing temperature due to
thermostop OFF and/or water
intake temperature below 50°
Check that the water supplying the
appliance is at least at 50°
If the problem persists call the after ‐
sales service
11 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR
THE USER)
The dishwasher is able to identify a number of malfunctions and show them on the display.
If the problem persists after the dishwasher has been switched off and back on, proceed as described
below:
E.1 Boiler temperature probe malfunction Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after ‐
sales service
E.2 Tank temperature probe malfunction Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after ‐
sales service
E.3 Water intake malfunction Water intake not completed in the maximum time
allowed
Check dynamic pressure in intake system: the water
intake filter may need cleaning, the tap may be
turned off or the rinsing nozzles may be fouled.
E.4 Boiler overheating. Switch the dishwasher off and wait a few minutes,
then switch back on and perform another cycle
If the problem persists call the after ‐ sales service.
E.5 Tank overheating Switch the dishwasher off and wait a few minutes,
then switch back on and perform another cycle.
If the problem persists call the after ‐ sales service.
E.6
Water not pumped out of tank
Inspect the filters for dirt and check that the drain
hose is not blocked, bent or crushed.
Check that the drain pump is not blocked by dirt by
removing the insert on the sump (from inside the
tank, see photo)
If the system fails to pump out because the drain
pump is fouled (as a result of incorrect filter
positioning), proceed as follows:
Bale out the dishwasher with a basin and disconnect