Smeg CVI38X, Operating Instructions Manual, Page: 5 / 6

9
Air exchange with activated charcoal filter
The way in which wines continue to mature depends on the ambient
conditions. The quality of the air is therefore decisive for preserving
the wine. An activated charcoal filter has been fitted in the lower area
of the rear wall of the appliance to ensure that the air throughput
remains at an optimum quality. We recommend that you replace the
filter once a year. Filters can be obtained from your dealer.
Changing the filter:
Take the filter by the handle. Turn it
90° to the left or right and remove.
Inserting the filter:
Insert with the handle in a vertical
position. Turn it 90° to the left or right
until it clicks into place.
Interior light
A lightbar is integrated into the
upper and lower compartments.
The interior light can be switched
on and off using button ➂ .
Caution - class 1M laser ra-
diation. When cover is removed, do not look directly at light
through optical instruments.
The lighting may only be replaced by the customer service
technician or by competent skilled personnel!
Furthermore, the brightness of the lighting can be adjusted.
• Press the LIGHT button
➂
.
• Press and hold button
➂
and at the same time press the tem-
perature setting buttons to increase or decrease the brightness.
GB
Defrosting
The appliance defrosts automatically. The water that forms on the
rear wall drains into a reservoir at the back of the appliance and
evaporates automatically through the compressor heat.
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the socket fuse intact?
Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects to
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Does the separately installed thermometer show the correct read-
ing?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes apply
and you cannot rectify the fault
yourself, contact the nearest
customer service department
stating the type designation
➊
,
index
➋
and appliance number
➌
as indicated on the type plate.
Cleaning
Before cleaning always switch off the appliance. Pull out the
mains plug or remove/unscrew the fuse.
Do not use steam cleaners because of the risk of injury and
damage.
• Use a glass cleaner to clean the glass surfaces.
• Only clean the door surfaces with a clean and soft cloth. If neces-
sary, moisten the cloth (water + detergent). Alternatively, use a
micro-fibre cloth.
• Clean the inside and equipment with lukewarm water and a little
detergent, with the exception of the wooden trims on the grid
shelves.
• Ensure that no cleaning water penetrates into the elec trical compo-
nents.
• Dry all parts well with a cloth.
• Do not damage or remove the type plate on the inside of the ap-
pliance. It is very important for servicing purposes.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
All types and models are subject to continuous improvement and
the manufacturer therefore reserves the right to make modifica tions
to the shape, equipment and technology.