Smeg CVI38X, Operating Instructions Manual, Page: 4 / 6

8
Setting the temperature
The temperature of both compartments can be set separately.
Select the appropriate compartment by press-
ing button
➇
or
➈
. The respective temperature
display flashes.
To reduce the temperature: Press the
DOWN
button.
To increase the temperature: Press the
UP
button.
The electronic controls will switch over automatically about 5 sec-
onds after the last time you pressed the button, and the actual
temperature will be displayed.
Audible warning signal
The audible warning signal helps to protect your wines against
excessive temperature fluctuations.
- It sounds when the door has been left open for longer than about
60 seconds.
- It sounds when the interior gets too warm or too cold. The
temperature display will also flash. The audible warning
device is switched off by pressing the
ALARM
button.
Fan button
Should you wish to use the wine cabinet to store wine for long periods
of time, activate the FAN button
➁
. The light in the display comes
on. Thereby a climate which corresponds to that of a wine cellar is
achieved inside the wine cabinet. Corks are prevented from drying
out due to an increased level of humidity.
Switching the appliance on and off
You are recommended to clean the appliance before switching it
on for the first time (see "Cleaning").
To switch the appliance on: Press the
ON/OFF
button
➀
until the temperature display lights up.
To switch the appliance off: Keep the
ON/OFF
button
pressed for
3
sec. so that the temperature display goes out.
Operating and control elements
➀ On/Off button
➁
Fan button
➂
Interior light on/off button
➃
Audible warning on/off button
➄ Child lock display
➅ Upper compartment temperature display
➆
Lower compartment temperature display
➇
Lower compartment activation button
➈
Upper compartment activation button
➉ Temperature setting buttons
Additional functions
In set-up mode you can set the child lock and adjust the brightness
of the display. The child lock is designed to protect the appliance
from being switched off accidentally.
Activating set-up mode:
• Press the FAN button
➁
for approx. 5 seconds.
- The display shows
c
for child lock.
Note: The value to be altered flashes.
• Select the required function by pressing the
UP/DOWN
button:
c = child lock, h = display brightness
• Now select/acknowledge the function by pressing the FAN button
➁
briefly:
> For c = child lock , press the
UP/DOWN
button
to select
c1 = child lock on or
c0 = child lock off and acknowledge with the FAN
button
➁
. When the symbol is lit, the child lock
is activated.
> For h = brightness , press the
UP/DOWN
button
to select
h1 = minimum to
h5 = maximum brightness and acknowledge with
the FAN button ➁ .
Exiting set-up mode:
Exit the set-up mode by pressing the ON/OFF button
➀
;
after 2 min. the electronic system switches over automatically.
The normal operating mode is activated again.