Smeg CT15-2, Instructions For Use Manual

Page: 11 / 18

GB-IE
Instructions for the User
12 12
7 USING THE WARMING DRAWER
7.1 Precautions and General Advice
When the warming drawer is used for the first time, it should be heated to
the maximum temperature for long enough to burn off any oily residues left
by the manufacturing process, which might contaminate foods with
unpleasant smells.
7.2 Operating settings
7.2.1 Stand-by mode
In this mode the whole system is disconnected and no indicator light or
display is lit.
7.2.2 Normal Operation
In this mode the system is generating heat. The display shows the
remaining operating time and the set temperature alternating each 2
seconds. The Timer and Temperature indicator lights light-up alternating
each 2 seconds and coordinated with the display indication. The Operation
indicator light is illuminated continuously until the Timer reaches zero.
To program the normal operation, proceed as follows:
a) Press the “F” key once or several times until the Timer indicator light is
flashing.
b) Press the “
↑
” or “
↓
” keys to set the desired operation time in the range
0h00 – 4h00.
c) Press the “F” key to validate. The Temperature indicator light starts to
flash.
d) Press the “
↑
” or “
↓
” keys to set the desired temperature in the range 30
– 75ºC.
e) Press the “F” key for 3 seconds or wait 5 seconds.
f) The Warming Drawer starts to operate with the set parameters.
7.2.3 Delayed Start
In this mode the Display shows the remaining time for the operation to
start and counting-down. The Operation indicator light will blink and the
Delayed Start indicator is illuminated.
To set a delayed start, proceed as follows:
a) Program the normal operation parameters as in points a) to d) of the
previous section.
b) Press the “F” key to validate. The Delayed Start indicator light starts to
flash.
c) Press the “
↑
” or “
↓
” keys to set the desired start delay in the range
0h00 – 9h50.
d) Press the “F” key for 3 seconds or wait 5 seconds.
e) The Warming Drawer enters the Delayed Start mode.
f) When the delay has elapsed the Warming Drawer starts to operate
with the set parameters.