2.
Remove the upper door.
3.
Remove the spacer.
4.
Loosen the middle hinge.
5.
Remove the lower door.
6.
Loosen and remove the lower pin.
7.
Tighten the lower pin on the opposite
side.
8.
Install the lower door.
9.
Tighten the middle hinge.
10.
Install the spacer.
11.
Install the upper door.
12.
Tighten the upper pin.
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal adheres to
the cabinet.
• The door opens and closes
correctly.
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the
cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry
out the above mentioned
operations, contact the nearest
Authorised Service Centre. The
Authorised Service specialist will
carry out the reversibility of the
doors at your cost.
Installing the appliance
CAUTION!
Make sure that the
mains cable can move freely.
1.
If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
x
x
2.
Install the appliance in the niche.
3.
Push the appliance in the direction of
the arrows (1) until the upper gap cover
stops against the kitchen furniture.
13
