Instructions for the Installer
2.
INSTALLING THE OVEN
The oven is designed for free-standing installation on a horizontal work-
top. It must be far enough from the wall behind it to allow easy access to
the terminal board for connection of the power supply lead. Installation
must be carried out by a
qualified engineer
in compliance with the
relevant EEC DIRECTIVES.
2.1
Electrical connection
Check that the power supply voltage and size are as specified on the
nameplate on the back of the oven.
This nameplate must never be
removed.
The oven is fitted with a H07RN-F three-core cable for operation at
230V
∼
and power supply plug.
The power supply lead supplied is of three-core H07RN-F type, gauge
3 x 1.5 mm
2
.
The power supply lead must be replaced by the manufacturer or an
authorised service centre to prevent all risks.
The power supply plug and wall socket must be of the same type (in
compliance with CEI standards). Check that the power supply line is
properly earthed. The use of reductions, adapters or junctions is not
recommended.
2.1.1
Safety thermostat
The oven is fitted with a safety device tripped in case of a serious
malfunction. To reset the safety device, call the after-sales service.
The manufacturer declines all responsibility
for injury or damage
caused by failure to comply with the above regulations or deriving from
tampering with even just one part of the appliance.
22