Ⅺ
. PARTS ASSEMBLE AND DISASSEMBLE
11.1 Nozzle Assemble and Disassemble
1.
Assembly
：
Select one befitting nozzle and insert it into the outlet’s steel pipe.
Press it with hand until the nozzle has been locked. It can be used after the
nozzle has been fixed reliably.
2.
Change:
Take the handle down from the holder after the nozzle has cool
down. There is a slot between the nozzle and the outlet’s steel pipe. By the slot,
put the handle on the disassembly plate of the nozzle that is fixed at the holder.
After that, fix the holder with one hand and pull out the nozzle. Change another
nozzle.
Note:
* The nozzle can be ordered by the custom.
* Change the nozzle after it has cool down.
11.2 Replacing Heating Element
Note: Replace the heating element assembly after it has cooled down.
1.
Revolve the handle enclosure down from the handle.
2.
Loosen and take down the three fixation screws fixing the steel tube and then
take out the heater element assembly.
3.
Change a new heater element assembly. Note: the heater and sensor are
designed in together with the steel tube.
4.
When changing new heater element assembly, the heater element pins must
insert into heater localizer and the sensor pins into the sensor localizer.
. CHARACTERISTIC
Ⅱ
1.
There are three programmable channels CH1&CH2&CH3, and it can set
the working time, airflow and temperature of each channel.
2.
With the function of password protection and locking buttons, protecting
from changing the parameters without admitted.
3.
The handle with magnetic switch can work in with the pedal switch
(option), and it is easy to operate.
4.
With automatically sleeping function and digital calibration function etc.
5.
Closed loop sensor, temperature can be controlled by zero voltage
triggering mode. Large power designs and the heating speed are rapid. The
temperature can be conveniently adjusted and the temperature is accurate
and stable and not affected by airflow.
6.
It is with a brushless whirlpool motor and the airflow is adjustable with a
wide range but no level.
7.
Automatic cooling unit can prolong the heating element’s life and protect
the handle.
Ⅲ
. USAGE
1.
It is suitable to the de-soldering of the SMD components, such as SOIC,
CHIP, QFP, PLCC, BGA and so on.
2.
It is suitable to hot shrink, drying, remove lacquer and mucosity, thaw,
preheating, disinfect and so on.
3.
It is suitable to the situation with different grade airflow.
4.
It is suitable to the hot air lead free de-soldering.
Page2
Page13
