BACnet Explorer Start-up Guide
Page 17 of 37
6
CONFIGURING THE BACNET EXPLORER
6.1 Configuration
By default the BACnet Explorer will open up on the BACnet Explorer page (
). Navigate to
Configuration by clicking on the Configuration button, found along the left side of the page. The BACnet
Explorer settings are split up into three types: Local Settings, Remote Settings and Network Settings.
The table below describes how the buttons at the bottom of each page function.
Button
Definition
Save
Click to save settings. Saving will require the device to be restarted.
Reset
Click to clear the current settings before saving; if settings have been saved the
Reset button is unavailable.
Defaults
Click to change settings back to factory defaults.
Figure 14: Configuration Button Functions
The following sections explain the setting parameters by type for BACnet Explorer configuration.
6.1.1 Network Settings
The IP Settings for the BACnet Explorer NG are used by BACnet/IP. The IP Settings can be edited in the
Network Settings section as shown.
Figure 15: Network Settings Page – IP Settings
