![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-10-100/tigerswitch-10-100_installation-manual_1300414037.webp)
3-1
C
HAPTER
3
I
NSTALLING
THE
S
WITCH
Selecting a Site
TigerSwitch 10/100 units can be mounted in a standard 19-inch
equipment rack or on a flat surface. Be sure to follow the
guidelines below when choosing a location.
◆
The site should:
•
be at the center of all the devices you want to link and near
a power outlet.
•
be able to maintain its temperature within 0° to 50° C
(32 to 122 °F) and its humidity within 10% to 90%,
non-condensing
•
provide adequate space (approximately two inches) on all
sides for proper air flow
•
be accessible for installing, cabling and maintaining the
devices
•
allow the status LEDs to be clearly visible
◆
Make sure twisted-pair cable is always routed away from power
lines, fluorescent lighting fixtures and other sources of electrical
interference, such as radios, transmitters, etc.
◆
Make sure that a separate grounded power outlet that provides
100 to 240 VAC, 50 to 60 Hz, is within 2.44 m (8 feet) of each
device and is powered from an independent circuit breaker. As
with any equipment, using a filter or surge suppressor is
recommended.
Summary of Contents for TIGERSWITCH 10/100
