Copyright
©
2010 SMC Networks
1
e
g
a
P
All Rights Reserved
I/M SMCMT01-Z rev. 1.0
9/1/10
continued on next page
The SMCMT01-Z Motion Sensor is a 35' passive infrared motion sensor with 80-pound pet immunity or a 50' standard sensor. It is highly sensitive to moving infrared
sources and features superior immunity to RFI, vibration, static electricity, temperature changes, and other false alarm sources. This Quick Start Guide has all the
information to get your SMCMT01-Z Motion Sensor up and running quickly. For detailed installation information, please see the SMCMT01-Z Motion Sensor User Manual.
SMCMT01-Z Motion Sensor Quick Start Guide
1
Verify Package Contents
SMC Networks provides the following items in your package:
1 SMCMT01-Z Motion Sensor with wireless radio installed
3 CR123A 3.0V lithium batteries
2 plastic masks
1 screw to secure the SMCMT01-Z to the wall-mounting
bracket
1 wall-mounting bracket
1 sheet of adhesive masking labels
1 cardboard undercrawl window mask
This Quick Start Guide
If an item is missing or damaged, contact your place of
purchase. The SMCMT01-Z specifications are:
Power supply: 2.6 Volt to 3.6 Volt
Battery type: 3V Lithium, Duracell® 123, Sanyo® and
Panasonic® CR123A
Life Expectancy: 3 years using 3 batteries
Current consumption walktest mode (LED flashing): 6 mA
Transceiver: ZigBee IEEE 802.15
Detection range: Up to 50 feet (15.2 m)
Mounting height: 6 to 10 feet (1.8 to 3 m)
Number of curtains: 9
Relative humidity: 10 to 85% non-condensing
Enclosure material: flame retardant ABS
2
Set the Switches
The SMCMT01-Z Motion Sensor circuit board has 2 switches to
configure range and mode. To access the switches, use a flat
head screwdriver to press the back cover tabs to release the
back cover. Looking at the rear of the device, the switches
are to the right of the bottom battery holder.
3
Install Batteries
With the rear panel of the SMCMT01-Z removed, install three
3V Lithium batteries.
A.
Remove the back cover, if installed.
B.
Remove any old batteries and dispose of them properly.
C.
Place the 3.0V lithium batteries in the holder and press
each one into place.
D.
Leave the back cover off and go to the next section.
Switch Description
ON (down) = Detection range is 50 feet (15.2 m).
RANGE
OFF (up) = Detection range is 33 feet (10.1 m). This is the
default.
ON (down) = Bi-curtain Mode. Increases false alarm
immunity in small areas. Intruders must pass through 2
curtains to trigger an alarm. Do not use for ranges under
5 feet (1.5 m). This is the default.
MODE
OFF (up) = Standard Mode. Use for wide-angle or single-
curtain applications. Intruders to only pass through 1
curtain to trigger an alarm.
Congratulations on purchasing your SMCMT01-Z Motion Sensor.
