IDX-OM-X011
Chapter 1
Safety
1.2
Hazard Classifications & Position of Hazard warning Labels
IDF190D/240D Series
1-2
1.2 Hazard Classifications & Position of Hazard
warning Labels
To ensure the safety of the operators, potential hazards are classified and marked with warning labels.
Confirm the potential hazards and positions of the labels before operation.
1.2.1
Hazard of Electricity
1.2.2
Hazard of Hot Surface
1.2.3
Hazard of Rotating Object
1.2.4
Hazard of Compressed Air Circuit
- Transportation, installation, and maintenance involve risks and should only be carried out by
people who have sufficient knowledge and experience about the product and its accessories.
- If there is abnormality, take actions below according to the operation manual.
- Read carefully the Chapter 6 Troubleshooting before taking actions.
- Do not start the product in any trouble. If failure occurs, immediately stop the product, and
contact maintenance personnel or a qualified person.
The product has surfaces that can reach high temperatures during operation. What is more,
there is also the danger of burn injury due to remaining heat after the power supply is cut.
Therefore, wait until the temperature of hot parts become 50
o
C and below.
WARNING
Before replacing or cleaning parts, be sure to bleed compressed air remaining inside of the
product until the gauge indicates “0”. If there is no relief to the pressure, high pressure can
propel objects at high velocity when unscrewing parts and cause injury.
WARNING
WARNING
Inside of this product, there is a power-supplying section with high voltage separated by the
cover panel. Do not operate the product without the cover panel.
WARNING
Since this product has parts that rotate during operation, there is the danger of burn injury
resulting from contact with them. Though sometimes those parts can temporarily stop the
rotation, they will rotate again, and so do not work with them while running mode.
WARNING
