Operation
HEC002-A/HEC006-A
8-3
7
High Temp. Cutoff
Sets upper limit of temp. which the
internal temp. sensor detects and
judges the unit should be shut off.
11.0 to 70.0
C
(0.1
C)
70.0
8
Low Temp. Cutoff
Sets lower limit of temp. which the
internal temp. sensor detects and
judges the unit should be shut off.
0.0 to 59.0
C
(0.1
C)
0.0
* How to return default value: Turn on the power supply with pressing [SEL] and [RET] keys,.
At this time, the settings of Level 2 and Level 3 are also reset.
8.4 Setting mode, Level 2
The method to enter to and return from setting mode Level 2 and which mode can be set in the level are
explained below.
8.4.1 How to enter and return
Press [SEL] and [ ] keys at the same time while power is turned on. Then, the indication on [MODE] is
changed depending on the number of press and the data in the indicated mode can be set. To return to
current temp. indication, press [RET] key twice.
When no input is done within 1 minute regardless of setting mode, the
current temperature indication is returned automatically.
8.4.2 Available mode in Level 2
The mode, which can be set in setting mode Level 2, is as shown on Table 8-2. The mode available in
Level 2 is supposed to be used normally for initial setting and maintenance and control PID is included.
The inputted data is written in EEPROM and memorized after the power
supply is turned off. The writing can be done up to 1 million times.
Summary of Contents for HEC002-A5
