SMC Networks EliteConnect SMCE21011, User Manual, Page: 186 / 258

– 186 –
23
S
PANNING
T
REE
C
OMMANDS
The commands described in this section are used to set the MAC address
table aging time and spanning tree parameters for both the Ethernet and
wireless interfaces.
bridge stp service
This command enables the Spanning Tree Protocol. Use the no form to
disable the Spanning Tree Protocol.
S
YNTAX
bridge stp service
no bridge stp service
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
This example globally enables the Spanning Tree Protocol.
Table 21: Spanning Tree Commands
Command Function Mode Page
bridge stp service Enables the Spanning Tree feature GC 186
bridge stp br-conf
forwarding-delay
Configures the spanning tree bridge forward
time
GC 187
bridge stp br-conf hello-
time
Configures the spanning tree bridge hello time GC 187
bridge stp br-conf max-age Configures the spanning tree bridge maximum
age
GC 188
bridge stp br-conf priority Configures the spanning tree bridge priority GC 188
bridge stp port-conf
interface
GC 189
show bridge stp Displays the global spanning tree settings Exec 190
show bridge br-conf Displays current bridge settings for specified
interfaces
Exec 190
show bridge port-conf Exec 190
show bridge status Exec 192
show bridge forward
address
Exec 192