SMC Networks EliteConnect SMCE21011, User Manual, Page: 187 / 258

C
HAPTER
23
| Spanning Tree Commands
– 187 –
AP(config)bridge stp service
AP(config)
bridge stp br-conf
forwarding-delay
Use this command to configure the spanning tree bridge forward time
globally for the wireless bridge. Use the no form to restore the default.
S
YNTAX
bridge stp br-conf forwarding-delay <seconds>
no bridge stp br-conf forwarding-delay
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
D
EFAULT
S
ETTING
15 seconds
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
This command sets the maximum time (in seconds) the root device will
wait before changing states (i.e., discarding to learning to forwarding). This
delay is required because every device must receive information about
topology changes before it starts to forward frames. In addition, each port
needs time to listen for conflicting information that would make it return to
the discarding state; otherwise, temporary data loops might result.
E
XAMPLE
AP(config)#bridge stp br-conf forwarding-delay 20
AP(config)#
bridge stp br-conf
hello-time
Use this command to configure the spanning tree bridge hello time globally
for the wireless bridge. Use the no form to restore the default.
S
YNTAX
bridge stp br-conf hello-time <time>
no bridge stp br-conf hello-time
time - Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) -1].
D
EFAULT
S
ETTING
2 seconds