Air Dryer
2 Transportation / Installation
2-2Installation
2
-
2
IDX-OM-K021
2-2 Installation
2-2-1
Location
The equipment should not be used or stored in the following conditions: Those conditions will cause
not only malfunction but also failures.
Environment where the equipment is exposed
to rainwater, moisture, salt water or oil.
Locations where the equipment is exposed to
dust or particles
Locations where the equipment is exposed to
flammable, combustible or explosive fumes.
Locations where the equipment is exposed to
corrosive gas or solvent.
Locations where the equipment is exposed to
direct sunlight or radiated heat.
Locations where ambient temperature is
beyond following range:
On-stream: 36 to 104
°
F (2 to 40
o
C)
Storage: 32 to 122
°
F (0 to 50
o
C)
(when there is no drain water
inside of the piping)
Locations where temperature changes rapidly.
Locations where strong electromagnetic noise
is generated.
Circumstances where static electricity is
produced or discharged through the body of the
equipment
Locations where strong high frequency shock
wave is generated
Locations where danger of thunder is apparent.
Locations where loading on vehicles, marine
vessels, and so on
Locations where altitude is higher than 2,000
meters
Circumstances where strong vibration or
impact are transmitted.
Circumstances where too much force and
weight are put on the body of the equipment
that causes it to deform.
Circumstances where not enough clearance
spaces to do maintenance
Spaces needed for maintenance
Front
: 2feet (0.6m)
Rear
: 2feet (0.6m)
Top
: 2feet (0.6m)
Right
: 2feet (0.6m)
Left
: 2feet (0.6m)
Locations where ventilation grille of the
equipment can be blocked.
Locations where the dryer could intake warm air
(for example from a compressor or other
dryers).
Condition which has sudden pressure/flow rate
changes.
IDFB Series
