![background image](http://html1.mh-extra.com/html/smc-networks/8708l2/8708l2_installation-manual_1300244045.webp)
C
ONNECTING
TO
A
P
OWER
S
OURCE
3-9
Connecting to a Power Source
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC socket located at the
back of the switch.
Figure 3-6 Power Socket
2. Plug the other end of the cable into a grounded, 3-pin, AC power
source.
Note:
For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the
socket type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure
the PWR LED is lit. If not, check that the power cable is correctly
plugged in.
4. If you have purchased a Redundant Power Supply, connect it to the
device and to an AC power source now, following the instructions
included with the package.
100-240V~
50-60Hz 2A
Summary of Contents for 8708L2
