![background image](http://html1.mh-extra.com/html/smc-networks/6709l2/6709l2_installation-manual_1300173039.webp)
C
ONNECTING
TO
A
P
OWER
S
OURCE
3-7
6. If you are sure the module is properly mated with the connector,
tighten the retainer screws by hand to secure the module in the slot.
7. Connect power to the switch.
Connecting to a Power Source
To connect a device to a power source:
1. Insert the power cable plug directly into the receptacle located at the
back of the device.
Figure 3-5. Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note:
For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the
receptacle type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure
the Power LED is lit. If not, check that the power cable is correctly
plugged in.
AC100-240 V 50-60Hz
AC100-240 V 50-60Hz
Summary of Contents for 6709L2
