www.smartwitness.com
Troubleshooting
The SVC1080-LCS does not power up (BLUE/RED LEDs do not turn on)
o
Please check the power and ground connections to the vehicle.
o
Use a multimeter to ensure the camera is receiving proper voltage
o
If connecting to fuse panel, check the vehicle fuse
o
Check the in-line fuse located on the red power cable of the SVC1080-LCS
o
*If none of these work, please contact SmartWitness
The Blue LED is off and the Red light is blinking
o
This is an SD card problem
Make sure the SD card is inserted properly into the camera (see step # 2
of Installation Steps)
Check to make sure the yellow switch on the SD card is in the UNLOCK
position
If the above do not work, try another SD card. If the 2
nd
SD card works,
then please contact SmartWitness to repair/replace the defective card.
6.
LED Reference Table:
SVC1080-LCS Status
Blue
Red
Buzzer
Booting
On
On
Off
Upgrade
Heartbeat
Heartbeat
Off
Continuous recording
4sec On, 1sec Off
(Continuously)
Off
Off
Event Pre
recording
2sec On/Off
(Continuously)
Off
Off
Trig
gered
/ event
recording
500msec On/Off
(Conti
nuously)
Off
100msec On
(1time)
SD card fault
Off
500msec On/Off
(Continuously)
Off
System fault
On
On
Off
No SD Card
Off
500msec On/Off
(Continuously)
5sec On
(1time)
SD Full
Off
2sec On/Off
(Continuously)
Off
Parking mode
8sec On, 1sec Off
(Continuously)
Off
Off
Power off
Off
Off
Off
For complete user manual, training videos, and technical support inquiries, please visit
support.smartwitness.com
