SmartWitness CP4S, User Manual

Page: 9 / 39

9
FUNCTIONS
G-Sensor Calibration
1. Set G-Sensor Axis using the configuration tool.
2. “selfadj.ini” should be in the config folder of the SD card.
3. Install the unit and park the vehicle on a flat surface .
4. Turn on the unit and wait until it start record.
5. Press and hold the “M1” button more than 2 seconds.
6. You will hear “beep” when you press “M1” button and then you will hear
another “beep” after 2seconds. Then release “M1” button.
7. Then calibration will be done within 2 seconds.
Built-in power backup (Super Capacitor)
When power to the unit is interrupted, CP4S creates the last
file using the internal Super Capacitor.
Time and Date
Set your time zone using the configuration tool then CP4S get’s time from the GPS
satellite's.
SD Memory Card Format
Please format [initialize] the SD card using the “CP4S Configuration Tool” software. A
blank SD card will also automatically format but will take a few minutes to complete.
G-Sensor Calibration is needed after installing the CP4S.
Remove the torx screw and then slide the SD door open, the blue LED on the
remote will turn off, then you can safely eject the SD card by pressing in to
eject it. After reinserting the SD card, close the door and attach the torx screw.
Safe Removal of SD Card