SmartTrike Xtend Mg+, Manual

Page: 12 / 32

-12-
Testing The Seat - Post Clamp Tightness
To test the tightness of the seat-post clamp:
Try turning the seat side-to-side.
If the Seat Post moves in the seat tube:
Tighten the Allen screw which is on the seat-post clamp.
Repeat this test again, until the seat post does not move in the seat tube.
Bell Feature
In case the mounting screw A is
factory installed remove it and set it
aside.
Open the clamp B just enough so that
the handlebar can be fit on.
Position the bell / accessory so that it
can be it is in proper level and position
as shown.
Tighten the screw securely. Be careful
not to over tighten it as this could
damage the clamp.
6mm
Bell Feature:
B
A
Reflector Installation
Reflector Installation:
1. Position the FRONT white reflector A so that it points in
a straight forward manner.
2. Tighten the clamp screw carefully.
NOTE: Do not over-tighten as this would damage the
clamp.
6mm
A