ASSEMBLE FRONT PANEL
BOTTOM PLATE
1834mm
1834mm
TOP PLATE
15mm
15mm
15mm
15mm
9
SELECT:
1 x 1.890 Wall Sheet
1 x 1.520 Top Plate (Red)
1 x 1.520 Bottom Plate (Green)
1 x 1.890 Door Jamb Flashing
1 x 1.890 Corner Door Jamb Flashing
16 x 30mm Galv Clouts
13 x Rivets
STEP 1:
Lay out 1 x Top Plate and 1 x Bottom Plate on a flat
surface as shown
STEP 2:
Using 2 x 30mm clouts, nail the Door Jamb Flashing flush with
the top of the Top Plate at the correct measurement as shown
in plan view. Pre drill holes using a 3.5mm drill bit
Check the distance between the top and bottom plates then use
a further 2 x 30mm clouts to nail the Door Jamb Flashings to
the bottom Plate. Pre drill holes.
STEP 4:
Place the door on the panel (In open position, approx 5mm
below top plate). Using two rivets, rivet the top and bottom
hinges to the Door Jamb Flashing.
Ensure the door closes properly, then fit remaining rivets.
STEP 3:
Place 1 x Wall Sheet on timber plates and rivet the sheets
together as shown.
Ensure that the top of the sheet is flush with the top of the
Top Plate and that the sides of the wall sheet overhang the
Top Plate by
15mm
as shown. Nail wall sheets to Top Plate
(two clouts per pan)
Nail the wall sheets to the Bottom Plate making sure that the
Plates are the correct distance apart and that the sides of the
wall sheets overhang the Bottom Plate by
15mm
.
Drill & rivet Door Jamb Flashings to wall sheets using four
rivets equally spaced on each side.
NOTE:
The
Doorway is standard at the left-hand end but can
be put on the right-hand end.
TOP
PLATE
DOOR
JAMB
NAIL
NOTE:
Door can be hinged on either side.
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 5), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
960mm
TOP PLATE
DOOR OPENING
Plan View
15mm
530mm
x3
x3
x3
