5
Step 4: Installing the Battery
1) Remove the (4) screws from the battery casing (Figure 9).
2) Align the battery (not included) with the contacts of the battery housing (Figure 10).
3) Install the battery casing and secure using the (4) screws (Figure 11).
NOTE:
The curved portion of the casing should face the pool wall.
4) Guide the battery housing into the light socket and press the housing toward the pool wall
(Figure 12).
5) Secure the battery housing by reinstalling the 2 screws removed in Step 1: Preparing the Light
(Figure 13).
Figure 9
Fi
gure 10
Figure
11
Figure 12
Figure 13
OPERATION
IMPORTANT:
Ensure that all plugs are removed from the inlet and outlet of the pool, the valve
of the filter is placed in the FILTER position and the water level of the pool is at or above the
minimum height requirement prior to restarting your filtration system.
Light Function (See Figure 14)
1) To turn the light ON, press and release the switch once.
2) To turn the light OFF, press and hold the switch.
NOTE:
The light will automatically shut off after 2 hours. Repeat Step 1 in this section if more
time is required.
Return Function and Fittings
3 fittings are supplied that thread into the front of the light
for different functions.
• Fitting A is used for pressure driving automatic cleaners
• Fitting B is an angled return to direct the water to the left
or right, against the wall of the pool.
• Fitting C is a straight return to direct the water toward the
center of the pool.
Figure 14
