4
Step 3: Installing the EZ Light/Fitting
CAUTION:
Be careful not to rest tools or light on the top ledge of the pool as objects may fall
into the pool.
IMPORTANT:
Have the EZ light prepared as instructed in Step R1, ensuring one gasket is on the
return.
1) Apply slight pressure on the return fitting, toward the pool wall (from the inside of the pool)
and loosen the large nut that secures the return fitting to the pool.
2) Remove the nut and any gaskets or washers from the return fitting.
3) Using a folded towel to block the water, push the existing return into the pool, making sure to
hold the return so it doesn’t fall to the bottom of the pool.
4) Fit the EZ Light and return into the center of the wall cut-out; ensure that one gasket is left on
the light to create a seal on the inside of the pool (see Step 1).
IMPORTANT:
Apply pressure to the front of the light until the large nut is secured to the fitting,
creating a water tight seal to the pool.
5) Install the second gasket, followed by the washer and nut on the return fitting of the light (Figure 4).
6) Tighten the nut to ensure a tight seal; do not over tighten (Figure 5).
IMPORTANT:
Make sure the fitting/light is level. If the light is not level, the battery may not rest
properly on the battery contacts.
NOTE:
The wall is now sealed. Pressure being applied to the light from the inside of the pool can now
be stopped.
7) Wrap the fitting with an adequate amount of Teflon tape and thread the fitting
into the back of the EZ light, do not over tighten (Figure 6 and 7).
8) Connect the filter hose to the slip fitting or soft sided fitting and tighten (Figure 8-shows slip fitting).
9) Remove any plugs and turn the valve position to FILTER.
Figure 4
Figure 5
Figure 6
Figu
re 7
Figure 8
