Smartpond DP700UV, Manual

Page: 6 / 28

VISIT WWW.SMART-POND.COM FOR PRODUCT INFORMATION AND TIPS.
EN
PUMP PERFORMANCE
Pump Specifications
Max Flow Rate
685-GPH at 1-ft height
Max Pumping Height
11.5-ft (0-GPH)
Power Consumption
50-watts / 0.85-amps
FLOW RATES (GPH)**
LIFT (feet)
10 110
9 185
8 270
7 345
6 405
5 465
4 520
3 575
2 635
1 685
0 745
PUMP
UV Specifications
Ballast Input Voltage
12-volts
Lamp Power
2.5-watts
UV Irradiance
1700 μ W/cm
2
Bulb Life
10,000 hours
Step 2.
Adjust the flow
control to the lowest setting.
Once the pump has been
turned on (after step 4) you
may adjust the flow control
to the preferred setting.
Step 3.
Place the pump
inside the pumpshield
®
.
Pull the drawstring until the
pumpshield
®
is fully closed
around the tubing and
power cord, and tie a knot to
secure.
Step 4. Place the pump into
the water and connect to a
properly grounded electrical
outlet.
2
3
4
**See P.12 or P.20 for metric data
MAINTENANCE
Before cleaning, always disconnect the pump from the power
source. Untie the drawstring on the pumpshield
®
and then
remove the pump from the pumpshield
®
. Clean the pumpshield
®
then place the pump back inside the pumshield
®
and test the
pump.
NOTE: If the pump performance is still unsatisfactory, proceed
to the next page.
GFCI outlet
4