Getting Started
CAUTIONS AND WARNINGS
Read and understand these instructions before installing and retain them for future reference.
This product is intended for installation in accordance with the National Electric Code and local regulations in the United States or
the Canadian Electrical Code and local regulations in Canada. Use indoors only. This product is not designed or approved for
use on power lines other than 120V 60Hz, single phase. Attempting to use this product on non-approved power lines may have
hazardous consequences.
-
Use only indoors or in outdoor rated box
-
Be sure that you have turned off the circuit breaker or removed the fuse for the circuit you are installing this product into.
Installing this product with the power on will expose you to dangerous voltages.
-
Connect using only copper or copper-clad wire
-
This product may feel warm during operation. The amount of heat generated is within approved limits and poses no
hazards. To minimize heat buildup, ensure the area surrounding the rear of this product is as clear of clutter as possible.
-
To reduce the risk of overheating and possible damage to other equipment, do not use this product to control loads in
excess of the specified maximum(s) or, install in locations with electricity specifications which are outside of the product’s
specifications. If this device supports dimming, please note that dimming an inductive load, such as a fan or transformer,
could cause damage to the dimmer, the load bearing device, or both. If the manufacturer of the load device does not
recommend dimming, use a non-dimming on/off switch. USER ASSUMES ALL RISKS ASSOCIATED WITH DIMMING AN
INDUCTIVE LOAD.
Identifying the Electrical Wires in your Home
-
LINE - usually black, may also be called HOT or LIVE, carries 110VAC electricity into the outlet
-
NEUTRAL - usually white
-
LOAD – usually red or blue
-
GROUND - bare copper wire or metal fixture (if grounded)
IMPORTANT!
If you are having any difficulties, consult an electrician. If you are not knowledgeable about, and comfortable with, electrical
circuitry, you should have a qualified electrician install X10 Dimmer Switch for you. If you have any questions, please consult an
electrician.
Page 4 of 8 X10WS12A Rev: 10/7/2011 6:27 PM
