62
63
English
User manual
smartgyro.es
PROBLEM SOLVING
TO CHECK A FUSE:
1.
Remove the fuse by pulling it out of its slot.
2.
Examine the fuse to make sure it is blown. See Images 10 and 20.
3.
Insert a new fuse of the proper rating
• • (2)
The battery voltage is too low
to operate
Charge fully until the charger
and gauges indicate they have
been completed.
• • • (3)
The battery voltage is too high
to operate the SmartGyro
Avanza
Contact your authorized provi-
der for help.
• • • • • • (6)
Throttle problem. It is possible
that the throttle control lever
was pressed when the key
was inserted.
Release the throttle control
lever completely. Then reinsert
the key.
• • • • • • • (7)
It is possible that the throttle
control lever was pressed
when the key was inserted.
Contact your authorized provi-
der for help.
• • • • • • • • (8)
The SmartGyro Avanza engine
is disconnected.
Contact your authorized provi-
der for help.
• • • • • • • • • (9)
The ignition controller has
been disconnected. You may
be trying to install the battery
while the ignition key is inser-
ted and the motor controller
may be in overheat protection
mode
Turn off your SmartGyro
Advances for a minimum of 10
minutes to allow the controller
to cool or attempt to re-insert
the key.
19. Working fuse 20. Fused fuse
WHAT HAPPENS IF THE SMARTGYRO AVANZA BATTERIES DO NOT CHARGE?
— Check the fuse located on the battery. Replace it if necessary.
— During the charging process check if the charger LED is on,
— Check the fuse located in the battery pack, Replace it if necessary.
— Make sure that both ends of the charger power cable are fully inserted.
— If the battery fuse burns continuously, contact your authorized dealer for technical service.
WHAT HAPPENS IF THE MAIN SWITCH TRIPS REPEATEDLY?
— If the main switch is triggered repeatedly, consult the authorized supplier.
— Charge the SmartGyro Avanza batteries more frequently. See IV. “Batteries and charge”.
— If the problem continues, have the batteries of your smartGyro Avanza tested by your
authorized supplier
If the battery status gauge is in the low load position and the engine moves with difficulty
when I press the throttle control lever:
— Fully charge the batteries of your smartGyro Avanza. See IV. “Batteries and charge”.
— Have your authorized supplier test the charge of each battery.
The replacement fuse must exactly match the rating of the previous fuse.
If fuses with the proper rating are not used, the electrical system may
be damaged.
