HGM7110DC Genset Controller
HGM7110DC Genset Controller Version: 1.0 2014-09-27 Page
11
of
68
4 OPERATION
4.1. PUSHBUTTONS
Stop
Stop running generator in Auto/Manual mode; Lamp test (press at
least 3 seconds); Reset alarm in stop mode; During stopping
process, press this button again to stop generator immediately.
Start
Start genset in Manual mode.
Manual Mode Press this key and controller enters in Manual mode.
Auto Mode
Press this key and controller enters in Auto mode.
Close/Open
Can control generator to switch on or off in Manual mode.
Mute/Reset
Alarm
Alarming sound off; If there is trip alarm, pressing the button at
least 3 seconds can reset this alarm.
Raise Speed
Control the genset accelerate in Manual mode.
Drop Speed
Control the genset decelerate in Manual mode.
Menu/Confirm
1) Enter into Menu interface;
2) Shift cursor and confirm the set information.
Up/Increase
1) Screen scroll;
2) Up cursor and increase value in setting menu.
Down/Decrea
se
1) Screen scroll;
2) Down cursor and decrease value in setting menu.
NOTE:
Pressing
to enter
into Menu interface; select “Parameters” and input correct
passwords allows the users to set parameters.
NOTE
: Pressing
and
simultaneously will increase LCD contrast; Pressing
and
simultaneously will decrease LCD contrast; When controller is powered on after
outage, LCD contrast will return factory default.
WARNING:
Default password is 00318, user can change it in case of others change the
advanced parameters setting. Please clearly remember the password after changing. If you
forget it, please contact Smartgen services and send all information in the controller page of
“
ABOUT
” to us.
