HGM6100NC-RM Remote Monitoring Module User Manual Page 13 of 14
7
INSTALLATION
7.1
FIXING CLIPS
—
Controller design is panel installation method, and it is fixed by clips.
—
Withdraw the fixing clip screw (turn anticlockwise) until it reaches proper position.
—
Pull the fixing clip backwards (towards the back of the module) ensuring four clips are inside
their allotted slots.
—
Turn the fixing clip screws clockwise until they are fixed on controller panel.
—
Care should be taken not to over tighten the screws of fixing clips.
7.2
OVERALL DIMENSION AND PANEL CUTOUT
Unit: mm
Fig. 5 Case Dimensions and Cutout
HGM6100NC-RM controller can be applicable for DC (8~35)V battery voltage environment.
Battery negative must be reliably connected to engine shell. The connection wire between
controller power B+ and B-, and battery negative and positive should not be less than 2.5mm
2
. If a
floating charger is fitted, please connect output line of the charger with battery negative and
positive directly, and then connect battery positive and negative to power input of controller
separately, for the purpose of preventing charger disturbing the normal running of controller.
